Sanyo LCD-24XAZ10F Instruction Manual

Also see for LCD-24XAZ10F: Service manual

Basic OperationsTurning the TV on or offWarning: When the TV is in standby mode, power is still flowing into the TV. For the sake ofenergy saving and safety issue, please disconnect the power cord to completely cut off thepower.To turn the TV on or off:Plug the power cord into an AC power outlet, press POWER to turn on the TV.Press button again to turn off the TV and put the TV in standby mode.To cut off the power completely, unplug the power cord from the power outlet.123Selecting the input source To select the input source:1 Press INPUT button.Press 6or 5to select the input source, then press ENTER.You can also select the input source using the following remote control buttons:2Selecting a channel You can use the following ways to change channels:! Press CH+or CH- to go to the next or previous channel. The skipped channels cannot be selected.! Press the number buttons to directly select any channel you want, then wait for thechannel to change.Note: Button presses must be within three seconds of each other.! To go to the previous channel viewed, press .! To browse among your favorite channels you setup, press FAVORITE buttonrepeatedly.Adjusting the volume! Press the VOL+ or VOL- to increase or decrease the volume.! Press the MUTE button to temporarily turn off the sound. To restore the sound, pressthe MUTE button again.To adjust the volume:Displaying programinformation You can press DISPLAY button to display current program information such as channelnumber, color/sound system, or video input source, etc. To clear the display, press thisbutton again or wait a few seconds and it disappears automatically.To display program information:12Note: If the TV does not receive a broadcast signal for several minutes, the TV willautomatically turn off and go into standby mode.! HDMI — Press to switch to HDMI mode.! COMP — Press to switch to COMPONENT mode.! VIDEO — Press repeatedly to cycle between the SCART/SVIDEO inputs.! VGA — Press to switch to VGA mode.! TV — Press to switch to TV mode.! USB — Press to switch to USB mode.InputVGAHDMIUSBTVMove EnterSCARTSVIDEOCOMPONENT