Sanyo LCD-24XAZ10F Instruction Manual

Also see for LCD-24XAZ10F: Service manual

Identification of ControlsMain Unit (back view)Main Unit (front view)1. Remote sensor2. Power indicatorLights blue when in operating mode.Lights red when in standby mode.3. POWER4. INPUTTo access Input menu5. MENUPress this button to access the main menu screen.6. CHPress these two buttons to directly change the TV channel;In menu operations, these buttons serve as up/down buttons.7. VOL+Press the VOL+ or VOL– button to directly increase ordecrease the sound volume level;In menu operations, these buttons serve as right/left buttons.Receives signals from the remote control.Do not block.Press this button to turn the unit ON from STANDBY mode.Press it again to turn the set back to STANDBY.^/^/–Note: Buttons on the TV control panel are touchbuttons. First touch of the button will illuminate it.Second touch will fulfill its function. Be sure buttonpresses must be quickly done before theillumination disappears and it is suggested to touchthe sensor center, otherwise the operation maynot fulfill successfully.51 2INPUT MENU CH VOL +3 4 5 6 7INPUT MENU CH VOL123114 5 6 7 8 9 10USBSCARTPC INAUDIO VGAS-VIDEORS-232 AV OUTVIDEO L AUDI O RY C /Pr rC /Pb bAUDI OHDMI1. USB port: Connect a USB device to this port.2. Headphone: Connect headphones to this jack.3. SCART: Connect a device with SCART connector to thissocket.4. HDMI: Connect an HDMI device to this jack.5. PC IN VGA/AUDIO: Connect a computer to thesejacks.6. RS-232: For service only. Do not use.7. S-VIDEO: Connect a S-Video output from a video deviceto this jack.8.9. COMPONENT IN: Connect a component video deviceto these jacks.10. RF: Connect an antenna or cable TV to this jack.11. AC IN: Plug the AC cord into this jack and into a poweroutlet.AV OUT: Connect a VCR to these jacks to recordprogram’s video.