Sanyo LCD-40XZ10F Service Manual

Also see for LCD-40XZ10F: Instruction manual

7) A prompt “Pass” will be displayed beside the key “Run” for successful burning as Fig. 6Fig. 6 A prompt “Pass” beside the key “Run” for successful burning8) Need not exit ISP burning interface and only repeat the process 3）and 5）to go on burningsoftware for other sets.Note 3: On-line burning and upgrading method from USB port1） Be sure to format a U disk as FAT32;2） Copy program file to the U disk with the name “Merge.bin”;3） Power on, be sure to switch to ATV or DTV channel and not to display OSD interface; insert the Udisk into a USB port, then USB upgrading process will begin automatically;4） Upgrading processes:A、Reading data from the U disk:A prompt “Searching USB” is displayed and an indicating light of U disk is twinkling;B、Burning Flash:A prompt “Updating! Please don’t power off!!!” is displayed and an indicating bar is showingupgrading schedule; the set will be in Standby mode after the burning process completed;5） Start up the set again, enter into factory menu to verify software version and time parameters;then execute item “RESET ALL” to complete the whole burning process.*** Method of burning from USB could not be sure to be suitable for all kinds of U disks, so please tryother U disks if necessary.