Sanyo LCD-40XZ10F Service Manual

Also see for LCD-40XZ10F: Instruction manual

1.2 Adjustment flow chart as Fig.1Fig.1 Adjustment flow chart2 Alignment instruction2.1 Unit adjustment2.1.1 According to the wiring diagram “9232KE5201JL”, connect power board, main board,IR board, key board correctly; then power on, check if the display is normal.2.1.2 Using method of factory menua) First press key “SOURCE”，then press number key “2、5、8、0” in turn to enter into initialfactory menu;b) Press keys “CH+” and “CH-” can move cursor to each page of initial factory menu, then presskey “OK” can enter into adjustment menu of each page;c) Press keys “CH+” and “CH-” can move cursor upwards and downwards within one adjustmentpage;d) Move cursor to one adjustment item, then press keys “VOL-” and “VOL+” can adjust it;e) Press key “MENU” can exit adjustment menu of one page to its superior factory menu;f) Press key “EXIT” can exit factory menu at any time;g) Press key “OK” can enter into inferior factory menu;Check if DDC、、HDCP KEY and FLASHhave been burned.combination adjustment for generalassemblywhite balance adjustmentConnect to central signal source, check ifTV functions are normal -omitted channel,analog parameters control, etc; check ifoutput of earphone and speaker arenormal.Input VGA signal，check if the display is normal;check if every function is normal -analogparameter control, horizontal/vertical center, etc.Input AV/SVIDEO/SCART signal，check iffunctions of every channel are normal.Input HDMI signal,check if the display is normal;check if every function is normal –analogparameter control, horizontal/vertical center, etc.setup before leaving factoryCheck accessories and packing.Input high-definition component signal(mode), check if every YPbPr function isnormal.