-169-TroubleshootingThe projector is detecting abnormal condition.IndicatorsProjector ConditionPOWERgreenLAMPredWARNINGTEMP.redWARNINGFILTERorangeSHUTTERblueLAMP 1/2REP.orangeThe temperature inside the projector is elevatedclose to the abnormally high level.The temperature inside the projector is abnormallyhigh. The projector cannot be turned on. When theprojector is cooled down enough and the temperaturereturns to normal, the POWER indicator lights greenand the projector can be turned on. (The WARNINGTEMP. indicator keeps blinking.) Check and replacethe filter.The projector has been cooled down enough and thetemperature returns to normal. When turning on theprojector, the WARNING TEMP. indicator stops blink-ing. Check and replace the filter.The lamp cannot light up. (The projector is preparingfor stand-by or the projection lamp is being cooleddown. The projector cannot be turned on until coolingis completed.)The lamp cannot light up. (The lamp has been cooleddown enough and the projector is in stand-by modeand ready to be turned on with the ON/STAND-BYbutton.)When either of the 2 lamps is out, the projector oper-ates with 1 lamp.The lamp has been used overtime. Replace the lampimmediately and then reset the lamp counter. The in-dicator will be turned off after resetting the counter.✽✽✽✽✽✽✽When the filter detects clogging, reaches a time set in the timer setting or runs out of the filter scroll, the WARN-ING FILTER indicator lights orange. When this indicator lights orange, replace the filter or the filter cartridge witha new one promptly. Reset the Filter counter and Scroll counter after replacing the filter cartridge.✽✽✽✽✽✽✽✽✽✽✽ ✽✽ ✽WARNING FILTERWhen the LAMP 1 REPLACE indicator and the LAMP 2 REPLACE indicator light orange, replace the projectionlamps with new ones promptly. And then reset the Lamp time after replacement of the lamps.LAMP REPLACE 1 and 2
