Sanyo PLC-HF15000L Service Manual

Also see for QuaDrive PLC-HF15000L: Brochure & specs Owner's manual Owner's manual Manual Manual

Contents

-0-Lens Mounting- 5 -Fig. 1010 Install the Upper Light-Block Plate intothe guide of Lower Light-Block Plate.(See Fig. 9)Note:L When installing the Upper Light-Block Plate, theLower Light-Block Plate should be lifted upward withyour hand.LMake sure the mark (UP/DOWN and FRONT/BACK)on Light-Block Plate is correct and set them properly.11 Replace and fix the Top Cover with two (2)screws A. (See Fig. 10)When using LNS-W03/LNS-W03E- When installing LNS-W03/LNS-W03E, use two (2)Light-Block Plates. Make sure the figure is correctand put in proper position. (See Fig.11)7 Before mounting the Light-Block Plate (No. 610335 4545), turn the projector on and move theprojected image to the most upper left withthe lens shift function. Then turn the projectoroff.< Insert the Light-Block Plate (No. 610 335 4545)in the direction shown in the figure to the right.The Light-Block Plate should encircle the lens.Rotate the Light Block Plate counter clockwiseuntil the convex side is in a downward position.Note: The side with "THIS SIDE BACK" must face backward.Fig. 9Fig. 11NO. 610 335 4545(On front of FK2B)TYPE FK2BUpper PlateLower Plate12 Turn the projector on and operate Lensshift, Zoom and Focus fully to check theLight-Block Plates. If Light-Block Plateinterferes with those operations, check theLight-Block Plate is set properly.CAUTION : Do not operate theprojector with Light-Block Plateremoved. Doing so may result inmalfunction of the projector.A ATop Cover- 6 -Focus Lock ScrewFocus Lock RingL mark (yellow)FOCUS ADJUSTMENTSet up the projector and project image on the screen.1. Loosen the Focus Lock Screw on the lens.2. Rotate the lens to obtain proper focus on centerarea of the screen.When the distance between the screen and lens is 1meter, set Lmark (yellow) of the lens on Focus LockScrew position.3. Lock the Focus Lock Screw securely.When proper focus is not observed at outer area of thescreen, proceed the following adjustments.4. Loosen the Focus Lock Ring on the lens. (Turn theLock Ring counter-clockwise.)5. Rotate the lens to obtain proper focus on outer areaof the screen.6. Lock the Focus Lock Ring securely. (Turn the LockRing clockwise.)If proper focus is not observed over the entire screen,repeat above adjustments 1~ 6.LNS-W03 and -W03EAdjust zoom first and then adjust focus.LNS-T03Rotate this part ofthe lens to obtainproper zoom.Rotate this part ofthe lens to obtainproper focus.1. Loosen the Focus Lock Screw on the lens.2. Rotate the lens to obtain proper focus on centerarea of the screen.3. Lock the Focus Lock Screw securely.Focus Lock ScrewRotate this part ofthe lens to obtainproper focus.LNS-W01Z