Sanyo PLC-SU22N Owner's Manual

24COMPUTER MODEPC ADJUSTMENTThis Projector can automatically tune to the display signals from most personal computers currently distributed.However, some computers employ the special signal formats which are different from the standard ones andmay not be tuned by Multiscanning of this projector. If this happens, the projector cannot reproduce a properimage and the image is recognized as a flickering picture, a non-synchronized picture, a non-centered picture ora skewed picture.This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to matchwith those exceptional signal formats and the projector has five independent memory areas to memorize thoseparameters manually adjusted. This enables you to recall the setting for a specific computer whenever you useit.Press the MENU button and the ON-SCREEN MENU willappear. Press the POINT RIGHT/LEFT buttons to select PCADJUST and press the SELECT button. Another dialogbox “Where to reserve” Menu will appear.In this dialog box, you can store the parameter into the areafrom “Mode 1” to “Mode 5.” When memorizing the newcomputer parameter, select the Mode with the message of“Free” by pressing the POINT UP/DOWN buttons and theSELECT button. To change the parameters of the Modepreviously set, select the Mode with “Stored.”12When the Mode is selected, Parameter adjustment dialog boxappears. Move the arrow to the item that you want to changeby pressing the POINT UP/DOWN buttons, and adjust the eachitem to match your computer. To change the value, presseither the POINT RIGHT button or the POINT LEFT button.Refer to the next page for adjusting each item.3Move the arrow to “Stored” and press the SELECT button. Theparameter is memorized in the selected Mode.4This Mode hasparameters beingstored.Close the PCADJUSTMENT Menu.The Vacant Mode.Manual set ComputerMode (1 to 5).Press the POINTRIGHT/LEFTbutton(s) toadjust the value.Press theSELECT buttonto set Full screenfunction on/off.To activate the Mode manually adjusted in this PCADJUSTMENT Menu, select the Mode at the SYSTEMSELECT Menu. (Refer to page 23.)5