Sanyo PLC-WL2500A Owner's Manual

Also see for PLC-WL2500A: Manual Manual Quick reference guide Owner's manual Specifications

Contents

Sanyo PLC-WL2500A Owner's Manual Manual pdf 63 page image

63When the projection lamp of the projector reaches its endof life, the Lamp replacement icon appears on the screenand LAMP REPLACE indicator lights yellow. Replace thelamp with a new one promptly. The timing when the LAMPREPLACE indicator should light is depending on the lampmode.For continued safety, replace with a lamp of thesame type. Do not drop a lamp or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp Cover. The inside ofthe projector can become very hot.CAUTIONLamp ReplacementCAUTIONMaintenance and CleaningFollow these steps to replace the lamp.Turn off the projector and unplug the AC power cord.Let the projector cool for at least 45 minutes.Loosen the three (3) screws that secure the lamp. Liftthe lamp out of the projector by using the handle.13Replace the lamp with a new one and secure the three(3) screws. Make sure that the lamp is set properly.Close the lamp cover and secure the screw.4Loosen the screw and open the lamp cover.2Connect the AC power cord to the projector and turnon the projector.6 Reset the lamp counterSee “Resetting the Lamp Counter” on the next page.5Lamp CoverScrewORDER REPLACEMENT LAMPReplacement lamp can be ordered through your dealer. When ordering a projection lamp, give the followinginformation to the dealer.● Model No of your projector : PLC-WL2500A● Replacement Lamp Type No : POA-LMP141(Service Parts No. 610 349 0847)Top PanelWhen replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may bebroken. If replacing the lamp of a projector which has been installed on the ceiling, you should alwaysassume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it.Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If piecesof glass get into your eyes or mouth, seek medical advice immediately.CAUTIONScrewsLampHandleLamp replacement iconWARNING:TURN OFF THE UV LAMP BEFOREOPENING THE LAMP COVERNote:The Lamp replacement icon (Fig.1) will not appearwhen the Display function is set to Off (p.46), duringFreeze(p.25), or No show (p.26).This indicator turns yellowwhen the projection lampreaches the end of its life.