Sanyo PLC-WL2500A Owner's Manual

Also see for PLC-WL2500A: Manual Manual Quick reference guide Owner's manual Specifications

Contents

Sanyo PLC-WL2500A Owner's Manual Manual pdf 9 page image

9⑤ S-VIDEO INConnect the S-VIDEO output signal from videoequipment to this jack (p.15).⑨ AUDIO INConnect the audio output signal from videoequipment connected to ⑤ or ⑩ to this jack.For a monaural audio signal (a single audiojack), connect it to the L (MONO) jack (p.15).⑧ COMPUTER / COMPONENT AUDIO INConnect the audio output (stereo) from acomputer or video equipment connected to ②,③ or ④ to this jack (pp.14,16).⑩ VIDEO INConnect the composite video output signal tothis jack (p.15).③ COMPUTER IN 1 / COMPONENT INConnect output signal from a computer, RGB scart21-pin video output or component video output tothis terminal (pp.14,16).⑥ AUDIO OUT (VARIABLE)Connect an external audio amplifier to this jack(pp.14-16).This terminal outputs sound from AUDIO INterminal (⑧ or ⑨) or HDMI terminal ② (digitalaudio).Never plug headphones and earphones intoAUDIO OUT jack.① LAN Connection TerminalConnect the LAN cable (refer to the owner’s manualof "Network Set-up and Operation").⑧⑨⑦ CONTROL PORTWhen controlling the projector with RS-232C,connect the control equipment to this connectorwith the serial control cable.⑩Part Names and Functions③ ④②①② HDMIConnect the HDMI signal from computer or videoequipment to this terminal (pp.14,16).④ COMPUTER IN 2/MONITOR OUTThis terminal is switchable and can be used forinput from a computer or output to the other monitor.Set the terminal up as either Computer input orMonitor output properly. [Used for Monitor out,this terminal outputs only incoming signal fromCOMPUTER IN 1/COMPONENT IN terminal (pp.14, 50)].Side Terminalis registered trademarks of HDMILicensing, LLC.⑤ ⑥ ⑦