Sanyo PLC-WL2503A Owner's Manual

Also see for PLC-WL2503A: Manual Manual Service manual Dimensional drawing Specifications

Sanyo PLC-WL2503A Owner's Manual Manual pdf 39 page image

ENGLISHItem DescriptionContrast .............................. Adjusts picture con-trast (0~ 63)Brightness ......................... Adjusts picture bright-ness (0~ 63)Color ...................................... Adjusts picture colorsaturation (0~ 63)Tint ......................................... Adjusts picture hue(0~ 63)Color temp........................ Sets a color tem-perature mode. {X Low,Low, Mid, High, Adj.Blackboard(Green),Colorboard}White balanceRed, Green, Blue ..... Adjusts each whitebalance respectively.(0~ 63)* When changing the value of thewhite balance, the color temp.indicates "User".Sharpness ................................ Adjusts picture sharpness. (0~ 15)Gamma.......................................... Adjusts brightness of darker part of the picture. (0~ 15)Noise reduction ................Switches noise reduction mode (OFF, L1, L2)Progressive ............................Switches progressive mode (OFF, L1, L2, Film)Reset............................................Resets the Image adjustment to previous levels.Store ............................................ Stores the Image adjustment values. Select an item [Image1 - Image4] fromthe pull-down menu and click Store button.Load ............................................. Loads the Image mode. Select an image mode from the pull-down menuand click Load button. There may not be available mode depending on theinput mode as shown in the table left.Image adj.This function is to adjust the projected picture image and save the image mode. To storethe adjusted value, click Store button, and to load the adjusted value, click Load button.Input sourceImage mode Video ComputerDynamic 4 4Standard 4 4Cinema 4 *Real * 4Blackboard(Green) 4 4Colorboard 4 4Image1 - 4 4 4✐ The mark "4" means that the available image mode in theselected input source. The error message appears whenselecting the disabled image mode indicated with "*".Control