Sanyo PLC-WM5500/L - 5500 Lumens Manual

Also see for PLC-WM5500: Owner's manual Brochure Manual Owner's manual Command list

PLC-WM5500/WM5500L Basic Serial Command Functional Specifications12/286.5 POWER ON CommandCommand “C00” [CR]DetailPower ONWhen already Power is ON, no operation is started. When sending thiscommand during Countdown in process, Countdown is terminated.Acceptable [ACK] [CR]ResponseUnacceptable “?” [CR]6.6 POWER OFF Command (Quick POWER OFF)Command “C01” [CR]DetailPower OFF (Standby)This command executes Quick Power OFF operation without displaying “PowerOFF?” message, which is displayed when Power is turned OFF withON/STAND-BY button of the projector or remote control.Acceptable [ACK] [CR]ResponseUnacceptable “?” [CR]6.7 POWER OFF CommandCommand “C02” [CR]DetailPower OFF (Standby)This command works the same way as when Power is OFF with ON/STAND-BYbutton of the projector and remote control.(When the command is sent once, “Power OFF?” message is displayed. If thiscommand is sent again while “Power OFF?” message is displayed, Power OFFoperation is executed.)When sending this command during Countdown in process, Countdown isterminated.Acceptable [ACK] [CR]ResponseUnacceptable “?” [CR]6.8 INPUT 1 CommandCommand “C05” [CR]DetailSelect Input 1. This command works differently from the command by “Input 1”key of the remote control. When Input 1 has been already selected, thiscommand does not execute the source switching; just for switching to Input 1.Although projector returns “OK”, Input search is not executed with this commandwhile Input button is set to Mode2 or Mode3.Acceptable [ACK] [CR]ResponseUnacceptable “?” [CR]6.9 INPUT 2 CommandCommand “C06” [CR]DetailSelect Input 2. This command works differently from the command by “Input 2”key of the remote control. When Input 2 has been selected, this command doesnot execute the source switching; just for switching to Input 2.Although projector returns “OK”, Input search is not executed with this commandwhile Input button is set to Mode2 or Mode3.Acceptable [ACK] [CR]ResponseUnacceptable “?” [CR]