Sanyo PLC-XC50 Service Manual

Also see for PLC-XC55: Brochure Owner's manual Manual Manual Specification sheet

Contents

-9-When the life of the projection lamp of this projectordraws to an end, the Lamp replacement icon appearson the screen and LAMP REPLACE indicator lights yel-low. Replace the lamp with a new one promptly. The tim-ing when the LAMP REPLACE indicator should light isdepending on the lamp mode.Lamp ReplacementTop ControlLamp replacement icon✔Note:• The Lamp replacement icon will not appearwhen the Display function is set to “Off”, dur-ing “Freeze”, or “No show”.MaintenanceThis indicator is yelloww h e n t h e l i f e o f t h eprojection lamp draws toan end.For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! Theglass can shatter and may cause injury.Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can becomevery hot.CAUTIONCAUTIONWhen replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may bebroken.If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that thelamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp covergently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyesor mouth, seek medical advice immediately.CAUTIONRefer to the next page for replacing a lamp.