Sanyo PLC-XD2200 Owner's Manual

Also see for PLC-XD2200: Easy setup Manual Manual Command list Dimensional drawing

Contents

5SettingRemote controlThis function allows you to change brightness of thescreen.Lamp control Lamp control✔Note:• Lamp mode cannot be changed for a while after turningon the projector. Lamp needs some time to stabilizeafter the power is turned on. Stored lamp mode will beactive after the lamp is stabilized.This projector provides two different remote control codes:the factory-set initial code (Code 1) and the secondary code(Code 2). This switching function prevents remote controlinterference when operating several projectors or videoequipment at the same time.When operating the projector in Code 2, both the projectorand the remote control must be switched to Code 2.To change the code for the projector:Select either Code 1 or Code 2 in this Setting Menu.To change the code for the remote control:Press and hold both the MENU and IMAGE buttonstogether for 5 seconds or more. After changing the code,make sure the remote control operates properly.✔Note:• When different codes are set on the projector and on the remote control, any operation cannot be made. In that case,switch the code on the remote control to fit the code on the projector.• If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.High ........... Brighter than the Normal mode.Normal ....... Normal brightnessEco ............ Lower brightness reduces the lamppower consumption and extends thelamp life.Remote control