-6-Check the number of lamp to be replaced on Lamp StatusDisplay.Remove the two screws on the Lamp Cover and press the buttonto open the Lamp Cover. (See right figure.)13Loosen the two screws and pull out the Lamp Assembly to bereplaced by grasping the handle.4Turn off the projector and disconnect the AC Power Cord. Allowthe projector to cool down for at least 45 minutes.2Replace the Lamp Assembly with a new one and tighten the twoscrews. Make sure the Lamp is set properly6Follow these steps to replace the lamp assembly.Replace the Lamp Cover and tighten the two screws.578Connect the AC Power Cord to the projector and turn theprojector on.Reset the Lamp Replacement Monitor Timer. (Refer to thesection "Lamp Replacement Monitor Timer" on page 41 of O/M.)NOTE : Do not reset the LAMP REPLACEMENT MONITORTIMER when the lamp is not replaced.CAUTION : Do not operate the projector while any of lamps is removed.It may result in malfunctions, fire hazard, or otheraccidents.LAMP REPLACEMENTBUTTONSCREWSLAMPCOVERSCREWSORDER REPLACEMENT LAMPReplacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following informationto the dealer. Replacement Lamp Type No. : POA-LMP29(Service Parts No. 610 284 4627)CAUTION For continued safety, replace with a lamp assembly of the same type. Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector canbe very hot. Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.Make sure which number of lamp needs to bereplaced on Lamp Status Display.Figure shows the case of replacing the LAMP 2.LAMP 1LAMP 2LAMP 3LAMP 4