Sanyo PLC-XK3010 Owner's Manual

Also see for PLC-XK2200: Owner's manual User manual Manual Manual Command list

Chapter 3 Basic Setting and Operation● When PJ lamp replacement time is reached:✐ Replace it with a new lamp immediately and reset the lamp counter. If the projector isused without resetting the lamp counter, the alert mail is sent to users in every power-on of the projector. This alert mail will not be sent when unchecking the mail sendingcondition "When PJ lamp replacement time is reached".TITLE: Message from projectorProjector Model Name: model nameTCP/IP: 192.168.1.201 Projector Name: Proj05It sends you following message.* The projector lamp has reached replacement time.Lamp ON 3000 h● When PJ needs service:TITLE: Message from projectorProjector Model Name: model nameTCP/IP: 192.168.1.201 Projector Name: Proj05It sends you following message.*Maintenance requirement from Projector is detected.Check up LED status of projector and consult with the dealer.MCI 3.3V OKMAIN ALL NG✐ The projector lamp was turned off, because the projector power circuit failed.Unplug the AC power cord and plug it, and then turn on the projector once again to verifyoperation. If the problem still persists, unplug the AC power cord and ask servicing to aqualified service personnel with the error information.Error informationExamples: Type and contents of alert mailWhen the projector has an abnormality, the following alert messages are sent to the regis-tered E-mail address according to your selected condition. Administrator or user can takean efficient action quickly by receiving this message. This is very useful to maintain andservice the projector.The following are examples of received messages.● When internal PJ temperature is too high:TITLE: Message from projectorProjector Model Name: model nameTCP/IP: 192.168.1.201 Projector Name: Proj05It sends you following message.* The Projector lamp is turned off, because internal projector temperature is too high.Wait for the completion of the cooling process and make sure the projector has beenturned into Standby. Then turn the projector on again.If the Indicator continues flashing, check the air filter for dust accumulation.