Sanyo PLC-XM100 Network Manual

Also see for PLC-XM100: Specification sheet Specifications Specifications Manual Brochure

1 ENGLISHSetting up the projectorItem DescriptionFiltercounter(h) ............ Displays the filter counter. Reset thetime after filter cartridge replacement.Click "Reset", a confirmation displayappears, and then click "OK", the timewill be reset.* Do not reset the Filter counter whenthe filter cartridge is not replaced.Scrollsremaining ............. Displays the scrolls remaining of thefilter. Reset the scroll counter after filtercartridge replacement. Click "Reset",a confirmation display appears, andthen click "OK", the time will be reset.* Do not reset the Scrolls remainingwhen the filter cartridge is not replaced.Filter control ....... Scroll the filter. Click "Roll-up", a confirmation display appears, and then click "OK", thefilter will be scrolled.Filter warning..... Sets the time to indicate the filter warning message on the screen. (OFF, 400H, 700H,1000H)PJ locksuspend ................. When the projector has a security of PIN code lock, disable this function temporarilyby pressing Execute button.Setting procedure1. Turn off the projector , disconnect AC cord from the outlet and then connect AC cord again.2. Access this page with the web browser.3. Click Execute button on the PJ lock suspend.* This function is disabled after the projector turns on.Shutter .................... Sets the shutter operation. (ON: close, OFF: open)Shuttermanagement ..... Sets the specified period of time when the projector shuts down after the projectoris left with the shutter closed.* The specified time can be set 5 to 180 min.Freeze ...................... Sets the image to freeze mode. (ON, OFF)Factory default .......... Sets all of the projector control items to the factory default setting except the fol-lowing items.Lamp Corres. Value, PJ time, Network PIN code, Network setting* This function is not effective for the settings of Network address settings, e-mailsettings, etc.Setting 3