Sanyo PLC-XM100 Network Manual

Also see for PLC-XM100: Specification sheet Specifications Specifications Manual Brochure

5 ENGLISHQ&AOperationQ Why can't be turned on/off with web browser?A Please make sure the settings of the projector are correct to use the projector.Please set the Standby mode of the projector's Setting menu to "Network". Referto "4. Controlling the Projector" ➔ "Power control and status check" (+ pp.32 - 33).Q Why can't I change the controls in the setting page with web browser?A Please make sure the projector is turned on. If it is in the standby mode, the settingis not effective to the projector. To control the projector with a web browser, theprojector must be in the powered-on condition.Q Why does it sometimes take a lot of time to complete the page display?A The display speed of the page depends on the network environment in which boththe projector and computer are placed. It may take much time to complete thepage display if network traffic is heavy. Please consult your network administrator.Q How many numbers of the E-mail address can I register in the E-mail set-ting page.A You can register up to 10 addresses.Q Why am I not receiving E-mail alert messages?A Make sure that the registered E-mail address and SMTP server address are correct. Ifthe SMTP server is located in your LAN (Local Area Network), the address should beset to the SMTP server in your LAN. The SMTP server located outside of your LANmay not be available for security reason. For further information please contact yournetwork administrator (+ p.25).It may be required for the authentication depending on the SMTP server. This projec-tor does not support this kind of SMTP server.

/ 60

Related manuals for Sanyo PLC-XM100