Sanyo PLC-XT35 Owner's Manual

Also see for PLC-XT35: Owner's manual Specification sheet Specification sheet Service manual Service manual

50CaptureThis function enables you to capture an image beingprojected to use it for a starting-up display or interval ofpresentations.Select Capture and press the SELECT button.A confirmation box appears and select [Yes] to capture theprojected image.After capturing the projected image, go to the Logo selectfunction and set it to “User”. Then the captured image willbe displayed the next time you turn on the projector orwhen you press the NO SHOW button (see page 31).To cancel the Capture function, select [No].Select [Yes] to capturethe projected image.Select [Yes] tostop capturing.CaptureLogo selectThis function decides on the starting-up display fromamong following options.User ......... Show the image you capturedDefault ..... Show the factory-set logoOff ........... Show the countdown display onlyLogo (Logo and Logo PIN code lock settings)This function allows you to customize the screen logo withLogo select, Capture, and Logo PIN code lock functions.Logo✔Note:• When “On” is selected in the Logo PIN code lockfunction, Logo select and Capture functions cannotbe selected.✔Notes:• Before capturing an image, select “Standard” inthe Image Menu to capture a proper image (p.41).• A signal from a computer can be captured up toXGA (1024 x 768). A signal from video equipmentcan be captured except for 720p, 1035i, and 1080i.• When capturing the image that has been adjustedby the Keystone function, the adjusted data isautomatically reset and the projector captures animage without keystone correction.• When the Logo PIN code lock function is set to“On,” the Capture function cannot be selected.• When starting to capture a new image, thepreviously stored image is cleared even if youcancel the capturing.• “User” cannot be selected when the image is notcaptured.Setting