Sanyo PLC-XU111 Owner's Manual

Also see for PLC-XU111: Service manual

Contents

41Video InputChoose Computer 2 by pressing the INPUT button on thetop control or press the COMPUTER button on the remotecontrol.Before using these buttons, correct input source should beselected through Menu operation as described below.1Computer2Input MenuUse the Point ed buttons to move the red arrowpointer to Computer 2 and then press the SELECTbutton.2After the Source Select Menu appeared for Computer2, move the pointer to Component or RGB(Scart) andthen press the SELECT button.3Input Source Selection (Component, RGB Scart 21-pin)Move the pointer (redarrow) to Computer 2and press the SELECTbutton.Input Menu iconMove the pointer toComponent or RGB(Scart)and press the SELECTbutton.Source Select MenuWhen the input source is coming from videoequipment connected to the COMPUTER IN2/COMPONENT IN terminal with aComponent-VGA Cable, select Component.ComponentWhen the input source is coming from videoequipment connected to the COMPUTER IN2/COMPONENT IN terminal with a Scart-VGA Cable, select RGB (Scart).RGB (Scart)✔Note:•Wired, Wireless, Memory viewer are for the Network function. Seeowner’s manual “Network Set-up and Operation” and owner’smanual of Memory viewer (optionally available).•When the Input Search function is set to “On1” or “On2”, theinput signal will be searched automatically (p.51).Computer 1 (Analog)VideoComputer 2COMPUTER buttonWiredTop Control INPUT buttonComputer 1 (Digital)Remote ControlComputer 1 (Analog)Computer 2Computer 1 (Digital)Direct OperationMenu OperationPress the MENU button to display the On-ScreenMenu. Use the Point 7 8 buttons to move the redframe pointer to the Input Menu icon.