Sanyo PLC-XU111 Owner's Manual

Also see for PLC-XU111: Service manual

Contents

9ComplianceAC Power Cord for the United Kingdom:This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of theplug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, marked thus. If the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover is required,ensure it is of the same colour as that visible on the pin face of the plug (i.e. red or orange). Fuse covers are available fromthe Parts Department indicated in your User Instructions. If the plug supplied is not suitable for your socket outlet, it shouldbe cut off and destroyed. The end of the flexible cord should be suitably prepared and the correct plug fitted.WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLET.The Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow ············ EarthBlue ································· NeutralBrown ······························ LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifyingthe terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter Eor by the safety earth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.WARNING: THIS APPARATUS MUST BE EARTHED.ASAThe AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada:AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories(UL) and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plugwill fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insertthe plug into the outlet, contact your electrician. GROUNDTHE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.AC Power Cord RequirementFederal Communications Commission NoticeThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changesor modifications should be made, you could be required to stop operation of the equipment.Model Number(s) : PLC-XU111Trade Name : SanyoResponsible party : SANYO FISHER COMPANYAddress : 21605 Plummer Street, Chatsworth, California 91311 U.S.A.Telephone No. : (818)998-7322