Sanyo PLC-XU300 Owner's Manual

Also see for PLC-XU300: Specifications Owner's manual Brochure Specifications Manual

Contents

Sanyo PLC-XU300 Owner's Manual Manual pdf 62 page image

6When the projection lamp of the projector reaches its endof life, the Lamp replacement icon appears on the screenand LAMP REPLACE indicator lights yellow. Replace thelamp with a new one promptly. The timing when the LAMPREPLACE indicator should light is depending on the lampmode.Follow these steps to replace the lamp.For continued safety, replace with a lamp of thesame type. Do not drop a lamp or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp Cover. The inside ofthe projector can become very hot.CAUTIONUnplug the AC power cord. Let the projector cool for atleast 45 minutes.Loosen the three (3) screws that secure the lamp. Liftthe lamp out of the projector by using the handle.13Replace the lamp with a new one and secure the three(3) screws. Make sure that the lamp is set properly.Close the lamp cover and secure the screw.4Loosen the screw and open the lamp cover.Connect the AC power cord to the projector and turnon the projector.5Lamp ReplacementCAUTIONTop ControlLAMP REPLACEindicatorLamp ScrewHandlesScrewLamp CoverScrewScrewCAUTIONWhen replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may bebroken.If replacing the lamp of a projector which has been installed on the ceiling, you should always assume thatthe lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove thelamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass getinto your eyes or mouth, seek medical advice immediately.✔ Note:• When Mode 2 is selected in the Lamp life control menu, if the projection lamp of the projector reaches itsend of life, the lampreplacement icon appears on the screen, and the projector is turned off automaticallyafter 3 minutes.• The Lamp replacement icon will not appear when the Display function is set to Off (p.46), during Freeze(p.25), or No show (p.26).Lamp replacement iconMaintenance and Cleaning