Sanyo PLC-XU305K Owner's Manual

Also see for 3000 ANSI LUMENS PLC-XU305: Brochure Specifications Specifications Datasheet Specifications

Contents

9Part Names and FunctionsRear Terminal⑦ S-VIDEO INConnect the S-VIDEO output signal from videoequipment to this jack (p.17).⑩ AUDIO INConnect the audio output signal from videoequipment connected to ⑦ or ⑪ to this jack.For a mono audio signal (a single audio jack),connect it to the L (MONO) jack (p.17).⑨ COMPUTER 1 / COMPUTER AUDIO INConnect the audio output (stereo) from acomputer or video equipment connected to ②or ④ to this jack. (pp16, 18)⑪ VIDEO INConnect the composite video output signal tothis jack (p.17).② COMPUTER IN 1 / COMPONENT INConnect output signal from a computer, RGB scart21-pin video output or component video output tothis terminal (pp.16,18).⑧ AUDIO OUT (VARIABLE)Connect an external audio amplifier to this jack(pp.16-18).This terminal outputs sound from AUDIO INterminal (⑨ or ⑩).③ MONITOR OUTThis terminal can be used to output the incominganalog RGB signal from COMPUTER IN 2 / DVI-Iterminal or COMPUTER IN 1/COMPONENT INterminal to the other monitor (p.16).⑤ LAN Connection TerminalConnect the LAN cable (refer to the owner’s manual“Network Set-up and Operation”). ⑫ USB Connector (Series B)In order to operate the computer with the remotecontrol and use the PAGE ▲▼buttons on theremote control during a presentation, connect theUSB port of the computer to the USB terminal witha USB cable (not supplied) (p.16).⑥ USB Connector (Series A)Connect the USB cable (refer to the owner’s manual“Network Set-up and Operation”).② ③① ④ ⑤⑥⑩ ⑦⑨① CONTROL PORTWhen the projector is controlled by a computer,connect to this jack with serial control cable.④ COMPUTER IN / DVI-IConnect computer output (Digital/Analog DVI-I type)to this terminal (p.16).⑧⑪⑫