35APPENDIXLAMP REPLACEMENTWhen the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow.When the image becomes dark or the color of the image becomes unnatural, replacement of the Lamp isrequired.Turn off the projector and disconnect the AC plug. Allow theprojector to cool for at least 45 minutes.Remove the two screws with a screwdriver and pull out theLamp Assembly by grasping the handle.13LAMP REPLACEMENT MONITOR TIMERReplace the Lamp Assembly with a new one and tighten the twoscrews. Make sure that the Lamp Assembly is set properly.Replace the Lamp Cover and tighten the screw.4Remove the screw with a screwdriver and remove the LampCover.2CAUTION For continued safety, replace with a lamp assembly of the same type. Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projectorcan become very hot. Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the LampReplacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops lighting.Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINTLEFT/RIGHT buttons to select SETTING and press the SELECT button (refer to the page 32, 33). Another dialog boxSETTING MENU will appear.1Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to “Lamp age,” and then press theSELECT button. The message "Lamp replace monitor Reset?" is displayed.2Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.Connect the AC Power Cord to the projector and turn theprojector on.6Follow these steps to replace the lamp assembly.Reset the Lamp Replacement Monitor Timer (refer to the section“Lamp Replacement Monitor Timer” below).Select [Yes] to reset the Timer.35LAMPASSEMBLYHANDLELAMP COVERNOTE : Do not reset the LAMP REPLACEMENT MONITORTIMER when the lamp is not replaced.ORDER REPLACEMENT LAMPReplacement Lamp can be ordered through your dealer. When ordering the Lamp, give the followinginformation to the dealer. Model No. of your projector : PLV-30 Available replacement Lamp Type No. : POA-LMP25 (Service Parts No. 610 287 5386)POA-LMP34 (Service Parts No. 610 291 0032)