Sanyo PLV-Z60 Owner's Manual

Also see for PLV-Z5: Service manual Mode d'emploi

12Part Names and FunctionsTo insure safe operation, please observe the following precautions:● Use two (2) AA or LR6 type alkaline batteries.● Always replace batteries in sets.● Do not use a new battery with a used battery.● Avoid contact with water or liquid.● Do not expose the remote control to moisture or heat.● Do not drop the remote control.● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.● Risk of explosion if battery is replaced by an incorrect type.● Dispose of used batteries according to the instructions.Point the remote control toward the projector (Infrared Remote Receiver) when pressing any buttons. Maximum operatingrange for the remote control is about 16.4’ (5 m) and 60 degrees in front of the projector.16.4’(5 m)60°Remote Control Battery InstallationRemote Control Operating RangePull up the lidand open it.Open the batterycompartment lid.Install new batteriesinto the compartment. Replace the compartment lid.Two AA size batteriesFor correct polarity (+ and –),be sure battery terminals arein contact with pins in thecompartment.1 2 3* When the batteries of the remote control are replaced, the remotecontrol code automatically returns to the initial code (Code 1) (p.39).Remote control