Sanyo VCC-9500P Instruction Manual

Also see for VCC-9500P: Brochure Installation manual

Contents

Sanyo VCC-9500P Instruction Manual Manual pdf 36 page image

Auto Mode Settings (AUTO MODE)35The Auto Pan mode allows you to pan between two surveillancelocations in loop. In this mode, you set a start point, an endpoint, moving speed, panning direction and other options. Youcan create up to four Auto Pan groups.1 Use the joystick lever (xy) to select [AUTO PAN],use the lever (vw) to select an Auto Pan groupnumber (1 - 4), and press the [ENTER] button.The AUTO PAN screen appears.2 Use the joystick lever (xy) to select [POSITION],use the lever (vw) to select “START y” (start point),and press the [ENTER] button.The START SETTING screen appears.3 Use the joystick lever to determine a start pointposition of the Auto Pan mode operation, and pressthe [ENTER] button.The AUTO PAN screen appears again.4 Use the lever (vw) to select “END y” (end point),and press the [ENTER] button.The END SETTING screen appears.5 Use the joystick lever to determine an end pointposition of the Auto Pan mode operation, and pressthe [ENTER] button.The AUTO PAN screen appears again.Memo: When a start point and an end point are set to the sameposition, the camera rotates through 360 degrees repeatedlywith the same tilting angle. The rotating direction isdetermined by the [DIRECTION] setting.6 Use the joystick lever (xy) to select [PAUSE TIME]and use the lever (vw) to select the duration forwhich the camera pauses at the start and endpositions.Available settings: 1S, 2S, 3S, 4S, 5S, 10S, 20S, 30S(S: Second, M: Minute)7 Use the joystick lever (xy) to select [DIRECTION]and use the lever (vw) to select the rotatingdirection during panning operation.Available settings: RIGHT (rotates clockwise),LEFT (rotates counterclockwise)8 Use the joystick lever (xy) to select [PAN SPEED]and use the lever (vw) to select the speed in whichthe camera moves between the start and endpoints.Available settings: 1 (slow) - 15 (fast)9 Use the joystick lever (xy) to select [RUN] – “SETy”, and press the [ENTER] button.The on-screen menu disappears, and the Auto Pan modeoperation starts.Pressing the [ENTER] button stops the operation.Memo: While monitoring in the normal screen, the Auto mode isturned on or off in the main screen of the system controller.For details, refer to the system controller instruction manual.B Panning between two surveillancelocations in loop (AUTO PAN)AUTO MODESEQUENCE yAUTO PAN yTOUR yAUTO RETURNTIMEA11SEQ A1MAUTO PAN 1POSITION yPAUSE TIMEDIRECTION[PAN SPEED]8RUN ySTART3SLEFTSETSTART SETTINGSTART SETTINGSTART SETTINGySETEND SETTINGEND SETTINGEND SETTINGySETWhile the camera operates in the Auto Pan mode, theauto focus function is disabled. In this case, the focusingmode is switched to the manual focus mode and thefocus is fixed to the position set in the START SETTINGscreen.However, when the panning speed is very slow or thecamera pauses at the start/end point for five seconds orlonger, the auto focus function is activated.y8yAUTO PAN 1POSITIONPAUSE TIMEDIRECTION[PAN SPEED]RUNMENUSTART3SLEFTSETBACK