Sanyo VCC-9500P Instruction Manual

Also see for VCC-9500P: Brochure Installation manual

Contents

Sanyo VCC-9500P Instruction Manual Manual pdf 41 page image

Alarm Settings (ALARM)408 Use the joystick lever (xy) to select [DURATION]and use the lever (vw) to select the interval afterwhich the next alarm becomes in effect.When an alarm is detected, another alarm signal will not beoutput until the duration specified in this setting has passed.Available settings: 5S, 10S, 15S, 20S, 30S, 45S, 1M, 2M,3M, 4M, 5M (S: Second, M: Minute)Memo: The interval setting for the next alarm to become in effect isapplied to the external switch whose number is the same asthe alarm input number. The alarm input from other externalswitches will be accepted.☞ After completing setting, use the lever to move the cursor to[MENU] and select “BACK” or “END”.The ALARM OUT screen allows you to perform the alarm outputsettings for each alarm output number.1 Use the joystick lever (xy) to select [ALARM OUT],use the lever (vw) to select an alarm output number(1- 2), and press the [ENTER] button.The ALARM OUT screen appears.2 Use the joystick lever (xy) to select [OUTPUT] anduse the lever (vw) to select an alarm output option.Available settings:• OFF: Does not output the alarm signal.• ON: Outputs the alarm signal.• REMOTE: Outputs the alarm signal by remote operation.(This option is available only when [ALARMOUT] is set to “2”.)3 Use the joystick lever (xy) to select [POLARITY]and use the lever (vw) to select the polarity for thealarm output signal.Available settings:• NO (Normal Open):Normally open so closed condition is detected as output.• NC (Normal Close):Normally closed so open condition is detected as output.4 Use the joystick lever (xy) to select [ALARM TIME]and use the lever (vw) to select a duration for whichthe alarm signal is output.The connected devices such as recorder, alarm buzzer andwarning lamp will operate for the duration you have specified.Available settings: 2S, 5S, 10S, 15S, 20S, 30S, 45S, 1M,2M, 3M, 4M, 5M, MANU(S: Second, M: Minute)Memo: “MANU” appears only when “REMOTE” is selected for[OUTPUT] in step 2.☞ After completing setting, use the lever to move the cursor to[MENU] and select “BACK” or “END”.The alarm output duration when using remote operation depends onthe setting for [ALARM TIME].• When selecting the value between “2S” and “5M”:Outputs the alarm for the duration you have specified.• When selecting “MANU”:Controls the alarm output duration by the AUX6 operation(ON/OFF) from external device.• When the alarm input is used as the external controlinput of the Day/Night function, “D/N” appears in thetop right of the screen. In this case, settings otherthan [POLARITY] cannot be made.• When multiple alarm inputs are receivedsimultaneously, the input whose alarm number issmaller precedes the others.B Setting the alarm output (ALARM OUT)ALARMyyALARM INALARM OUTALARM DISABLEMOTIONALARM DISPLAYPRESETMENU11OFFOFFOFFOFFBACKALARM OUT 1OUTPUTPOLARITYALARM TIMEPRESETMENUONNO5SOFFBACK• When selecting “REMOTE”, “MANU” isavailable for [ALARM TIME] enabling themanual operation of the alarm output.• When selecting “REMOTE”, the alarm signalwill not be output automatically even when thealarm is detected.The alarm output duration for remote operationWhile the alarm is output using remote operation, normalalarm output cannot be used.