Sanyo VPC-E1403 Instruction Manual

3PrefaceAbout this ManualThis manual is designed to assist you in using your new digital camera. All information presented is asaccurate as possible but is subject to change without notice.CopyrightThis manual contains proprietary information protected by copyright. All rights are reserved. No part of thismanual may be reproduced by any mechanical, electronic or other means, in any form, without priorwritten permission of the manufacturer.© Copyright 2010Federal Communications Commission (FCC) ComplianceThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the distance between the equipment and the receiver.• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Warning: A shielded-type power cord is required in order to meet FCC emission limits and toprevent interference to radio and television reception. Use only shielded cable to connect I/Odevices to this equipment. Any changes or modifications not expressly approved by themanufacturer may void your warranty and service agreement.Declaration of ConformityThis device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:• This device may not cause harmful interference.• This device must accept any interference received, including interference that may cause undesiredoperation.Trademark RecognitionWindows 2000/XP/Vista/Win7 are registered trademarks of Microsoft Corporation in the United Statesand/or other countries. Windows is an abbreviated term referring to the Microsoft Windows OperationSystem. All other companies or product names are trademarks or registered trademarks of their respectivecompanies.Safety and Handling PrecautionsCamera Information• Do not take apart or attempt to service the camera yourself.• Do not expose the camera to moisture, or extreme temperatures.• Allow the camera to warm up when moving from cold to warm temperatures.• Do not touch the camera lens.• Do not expose the lens to direct sunlight for extended periods.• Do not use abrasive chemicals, cleaning solvents or strong detergents to clean the product. Wipe theproduct with a slightly damp soft cloth.