Sanyo Vizzon HT32546 Owner's Manual

Also see for Vizzon HT27546: Owner's manual Quick and easy setup

6 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032NOTES:Channel information found during the All Channel Search isstored in the Channel Scan Memory database. After the AllChannel Search is completed, the DTV will tune to the lowestDigital channel or lowest Analog channel if no digital channelsare found.If the DTV does not detect anydigital or analog channels, amessage advising the viewerto check the cables andantenna connections willappear. In this case, you mustpress the CHANNEL UP(CH )key again to repeat thechannel search process. Ifafter two searches the DTV still fails to detect any channels,the DTV will tune to analog channel 3. These two channelsearches are necessary even if you plan to use the DTVonly as a monitor.If no analog or digital channels are found after the secondsearch, All Channel Search will default to off-air analog chan-nels 2 through 69 and digital channel D3-1. Select analogchannels using the remote control keypad. See page 12, itemnumber 2.4 ANA (Analog) ANTENNA SIGNAL(Optional)To change the initial ANALOG tuning system setup(from antenna to cable or cable to antenna, use theon-screen menu. See “Ana (Analog) AntennaSignal” on page 16.2 INSTALL TWO “AAA” BATTERIESIMPORTANT NOTE: Spent or discharged batteries must be recycledor disposed properly in compliance with all applicable laws. Fordetailed information, contact your local County Solid WasteAuthority.• Install two “AAA” Batteries (notincluded) so that the “+” and“–” marks on the batteriesmatch the “+” and “–”marks inside the Remote.To review the Remotefunctions, go topages 12 ~ 13.NOTE: Use two “AAA”Alkaline batteries. Remove the batteries if the remote control will not be used for amonth or more. Weak batteries may leak and cause damage.(Normal battery life is roughly six months.) If batteries have leaked in the Remote Control Unit, carefully wipethe case clean and load new batteries.3 ALL CHANNEL SEARCHWhen the television is powered on for the firsttime, it automatically checks for the presence of anRF signal.• Press the POWER key toturn on the DTV.• Then press the CHANNELUP (CH ) key to automat-ically search for availablechannels: Digital (ATSC)and Analog (NTSC).The All Channel Search con-tains two processes that areexecuted simultaneously fordigital and analog channels.The Search will take a fewminutes to complete.