26Chapter 4 Wired LAN configurationsSDSetting ProcedureSetting procedures and contents differ depending on the LAN installation location.When installing, consult your system administrator to set up the LAN appropriately.Connect the LAN cable to the LAN connection terminal of the projector.Network environment settingsSet the Wired LAN network through the projector menu.Detailed network settings will be made with browser. Refer to “6. Basic setting and operation” (p43-62).First, complete the settings described in this chapter before performing steps in “6. basic setting andoperation.”1. Turn on the projector and select “Wired” from the input menu of the projector.The projector’s Link Lamp will be on and the Access Lamp will start to blink. If the “Wired setting” is“Off”, it will not blink. Follow step 2 and 3 to blink the lamp.2. Select “Wired Setting” in the projector menu, and press SELECT button.Select similar LAN environment among LAN1, 2 and 3 with the Point 7 8 buttons. (LAN1, 2, and 3are the factory default setting environments. You can select three different environment amongsetting LAN1–3. For each setting, refer to the chart on page 31.)When selecting “Off” in the “Wired setting”, the LAN connection will be cut off. Use the functionwhen disconnecting the projector from the network.3. Press the Point button then the “Please wait...” message will appear and switching operation willstart. Switching will take a while and after completing the operation, the “Ready for use” message willappear. During the switching period, the projector cannot be operated.Connecting to the LAN lineLAN CableLAN ConnectionTerminalSpeed Lamp (Green)Light according to thespeed of the connectednetwork.10 Base-T.........Off100 Base-T ......On* When the LAN setting is “Off”, the two lampswill not be on.LINK/ACT Lamp (Orange)Light or blink orange whenthe projector is connectedto the network.
