Sanyo XU88 - PLC XGA LCD Projector Owner's Manual

Also see for PLC-WXU30A - 3700 Lumens: Specifications Specifications Specification sheet Owner's manual

Contents

82Chapter 7 Controlling the projectorStatusIf some of the registered projectors are disabled by some reasons(such as disconnecting the power source, disconnecting the LANcable, disconnecting from the network), control changes willcontinue to be effective for the projectors that are still active.At the same time, the deactivated projectors are excluded fromthe multi-control. The status of the registered projectors are in-dicated under the projector name. See the table below for statusindications.✐ If the multi-controlled projector is in the standby mode, items of "PC adj.", "Control" and "Setting" cannotbe operated.✐ Cannot register, delete or change the multi-control setting during using the network viewer function.✐ It is recommended that a specified projector should be chosen for setting as a master when you usethis multi-control function. The control for the multi-controlled projectors will become too complicatedoperation if this function is used for each projector.✐ If the registered projector is not connected to the network, it will take a while to complete the multi-controloperation because of waiting for the response from each registered projector.✐ There are some disabled items in the multi-control function for the light mode.Change the mode of the registered projectorTo change the mode of the registered projector, select a mode with the pull-down menu button underthe IP address of the target projector and then click Set button.Status Description(blank)........................The projector is connected to the network correctlyNo connect ..............The projector may not be connected to the network. Please check the connection and networkconfiguration of this projector.PIN code error .................The PIN code is incorrect. The PIN code for the multi-controlled projectors must be the same.Change the PIN code of this projector to the common PIN code. (p.30, p.40)File Error .................... Not displaying the images. Check if this projector is using the Network Capture function orNetwork Viewer function individually, or in the standby mode.* The projector updates the status at the time when the multi-control function is executed.Mode OperationControl....................... Controlling the projectorBoth control ................... Controlling and displaying imagesVisual control.................. Displaying the imagesOFF.............................. Excluding from the multi-controlDelete ........................ Deleting from the multi-controlStatus* The multi control item is not changed during using the networkviewer function. It is not available with the light mode.