EN-38TroubleshootingRefer to the symptoms and solutions listed below before sending the camera forrepairs. If the problem persists, contact your local reseller or service center.Symptom Cause Solutions / CorrectiveActionsThe power does notcome on.The batteries are not loaded. Load the batteries correctly.The batteries are exhausted. Replace with a new set ofbatteries.The batteries orcamera feels warm.Long period of continuous useof the camera or the flash.Even if I press theshutter button, thecamera does notshoot.The shutter button is notpressed all the way down.Press the shutter button all theway down.The internal memory ormemory card does not haveany free capacity.Insert a new memory card, ordelete unwanted files.The flash is charging. Wait until the status LED stopsblinking.The memory card iswrite-protected.Remove the write-protection.Although it is set toauto focus, it doesnot focus.The lens is dirty. Wipe clean with a soft, dry clothor lens paper.The distance to the subject issmaller than the effective range.Get your subject within theeffective focus range.Files cannot bedeleted.The file is protected. Cancel protection.The memory card iswrite-protected.Remove the write-protection.Cannot downloadimages.The free space on the harddisk in your computer may beinsufficient.Check whether the hard disk hasa space for running Windows,and if the drive for loading imagefiles has a capacity at least thatof the memory card inserted inthe camera.No power supply. Replace with a new set ofbatteries.