5. READ (X) AND RESET (Z) REPORTS EO1-110955-45.1 COMBINATION REPORTS5.1 COMBINATION REPORTSMultiple reports can be programmed to be issued in one operation sequence. The following are reportsprogrammable for combinations (max. 5 reports in one table, max. 3 tables). Ask your TOSHIBA TECrepresentative for information of the contents of your Combination Report Tables or for changes.REPORT NAME AVAILABLE REPORTSFinancial Report X Z GTX GTZAll Cashier Report X Z GTX GTZAll Salesperson Report X ZCredit Company Sales Report X Z GTX GTZDepartment Group Report X GTXMedia Sales and In-drawer Report XHourly Range Report X ZAll Department Report X Z GTX GTZAll Media Sales & Cash-in-drawer Report XAll PLU Report X Z GTX GTZAll Customer Files Report XPLU Group Sales Report X Z GTX GTZKEY OPERATION: Mode Lock: X for ReadZ for ResetEnter the Report Combination-ID No.:None (simply depress [AT/TL]): Daily Combination Report Table No.1200: GT Combination Report Table No.11: Daily Combination Report Table No.2201: GT Combination Report Table No.22: Daily Combination Report Table No.3202: GT Combination Report Table No.3NOTES: 1. When the mode set for taking combination reports does not match the mode of a reportcontained in the table, that report will be skipped.2. If no combination reports data have been programmed, Combination Report Table No. 1 (whichis issued by depressing the [AT/TL] key alone for Daily Reports and depressing 200 [AT/TL] forGT Reports) is auto-preset with All Department Report and Financial Report. It will be active asTable No. 1 content unless no data are programmed for Table No. 1.3. The report output order is determined by the order programmed in each table.4. The drawer will open when a contained report is ruled to open the drawer.5.2 GENERAL NOTES ON REPORT TAKINGS1. The cashier signed-OFF or signed-OUT condition is required for taking any Z reports in the Code EntryMethod. (Otherwise, an error will result when the Mode Lock is turned to the “X” or “Z” position.)2. Reset reports will be printed on the receipt roll as well as on journal, and issued, regardless of the currentReceipt-ON/OFF status.3. The [ITEM CORR] (or [VOID]) key may be depressed halfway during printing a report, for the purpose toabort the receipt issuance (except for some short reports). When a report-abort has been operated for a resetreport, the memory of the report data will not be cleared.4. The drawer will open at the starting of printing the reports which are stated with “(Drawer opens)” in the Dailyand GT report table. However, the drawer may remain closed if so selected by a program option. Thisselection is applied only to the Financial Report.| | [AT/TL]
