TEC MA-1450-1 Series Owner's Manual

Also see for TEC MA-1450-1 SERIES: Owner's manual

Contents

TEC MA-1450-1 Series Owner's Manual Manual pdf 113 page image

6. PROGRAMMING OPERATIONS EO1-110956-86.5 CONDITION REQUIRED FOR PROGRAMMING OPERATIONS6.5 CONDITION REQUIRED FOR PROGRAMMING OPERATIONSAt the top of each programming operation a “CONDITION” is given. Unless the register satisfies this condition,the programming operations will not be allowed.There are two types of conditions:“Any time outside a sale”It means that the programming operation is allowed when a sale is finalized before going into any other saleentry.“After ...Reset”It means that the designated reset report must be taken before entering the programming operation. And anerror will result if the operation is attempted without taking the report. However, the words “After ... Reset” donot necessarily mean “immediately after ...”.When the designated reset report has already been taken and then some operations are performed in theSET, X, or Z mode, the condition “After ... Reset” is still satisfied and the programming operation is stillallowed.On the contrary, when the designated reset report has been taken but then some sales data relating to thatreport’s output data are entered in the REG, MGR, or - mode, the programming operation will no longer beallowed and the same reset report must be taken.Thus the condition “After ... Reset” indicates that all the sales data relating to the report data must be zero(except non-resettable memory data). Because of this “CONDITION” requirement, the report data will beprotected from any inconsistencies of sales data entered in the period from a resetting of the report to anotherresetting of the same report next time.6.6 STORE NAME/MESSAGE AND COMMERCIAL MESSAGEPROGRAMMING (Submode 1)CONDITION Any time outside a saleOPERATION Mode Lock: SET1 [@/FOR] |Line No.| [ST]. . .. . .Submode No.Repeat for another line.1 to 7 or 5 to 7(See NOTE 2 on the next page.)Character Entries [ST] [AT/TL](For sequentially programminglines, the line numberspecification can be skipped.)max. 24 characters/line(See CHARACTERENTRIES at the beginningof this chapter.). . .To completethis line. . .NOTES: 1. For each line, a maximum of 24 regular-sized characters or 12 double-sized characters may beentered. A combination of both types is also available.To complete thisprogramming operation