6. OUTLINE OF PREPARATION PROCEDURE BEFORE OPERATING THE ECR EO1-110956-4Installing the Journal Roll16.1 INSTALLING THE RECEIPT/JOURNAL ROLLFollow Steps 1 to 5 for “Installing the Receipt Roll” on thepreceding pages, except that the paper roll should be placed innerside holder of the two holders.2There are the following two ways of a journal paper feedprocedure.A: Manual installationB: Installation using the [JF] keyA: Manual installation1 Lift the green lever on the journal side.2 Insert paper from the rear of the printer until the leadingedge of paper comes out by 30 cm.3 Insert the leading edge of paper into the slit of the take-upreel to take up paper two or three times.4 Place the take-up reel on the take-up holder.5 Lower the green lever.6 Attach the receipt cover.B: Installation using the [JF] key1 Insert paper from the rear of the printer until it won’t go nofurther.2 Press the [JF] key to feed paper until the leading edge ofpaper comes out by 30 cm.3 Insert the leading edge of paper into the slit of the take-upreel to take up paper two or three times.4 Place the take-up reel on the take-up holder.5 Attach the receipt cover.
