5. PROGRAMMED DATA VERIFICATION EO1-111495. PROGRAMMED DATA VERIFICATION5- 15. PROGRAMMED DATA VERIFICATIONWhenever programming operations are performed, it is recommended to issue Program Verificationreceipts to check the programmed data before entering any other operation. The print format of eachprogram reading is almost the same as that of the program receipt.Anytime outside a saleControl Lock: X or SET1) Programmed data read for each Submode• X mode90 [AT/TL] 01 [#/NS] |Submode No.| [AT/TL] [#/NS]• SET mode90 [#/NS] 01 [#/NS] |Submode No.| [AT/TL] [#/NS]NOTES: 1. Printing will be cancelled by depressing the [C] key during report print.2. The pass code assigned to individual cashier is printed not in X mode but in SET mode.2) Zone PLU Read• X mode90 [AT/TL] 02 [#/NS] |Zone-start PLU Code| [X/TIME] |Zone-end PLU Code| [AT/TL] [#/NS]• SET mode90 [#/NS] 02 [#/NS] |Zone-start PLU Code| [X/TIME] |Zone-end PLU Code| [AT/TL] [#/NS]NOTES: 1. Printing will be cancelled by depressing the [C] key during report print.2. The Zone-end PLU Code must be bigger than the Zone-start PLU Code. Failure to do this maycause an error.OPERATION2 digits (01 to 59)2 digits (01 to 59)CONDITION14 digits 14 digits14 digits 14 digits ;; 6(&7,21 7RPDWR Zone-start PLU CodeZone-end PLU CodeWhen the report is issuedin X mode: XWhen the report is issuedin SET mode: P R G 3RWDWR 70
