TEC Sterling G-Series Owner's Manual

Also see for Sterling: Owner's manual Owner's manual

Contents

TEC Sterling G-Series Owner's Manual Manual pdf 10 page image

Removing Your LP Gas CylinderProcedure:1. Close the Cylinder Valve by turning the Handwheelclockwise until it stops.2. Remove the Coupling Nut by turning it counter-clockwise.3. Release the latch and remove the cylinder from thegrill.Quick Disconnect Instructions(See Figure 4.)Procedure:1. To connect, push back Sleeve of Socket. (See FigureA.)2. Insert Plug (See Figure B.), release Sleeve.3. Push Plug until Sleeve snaps forward locking Plug inSocket (See Figure C.). (THIS AUTOMATICALLYTURNS ON GAS.)4. To disconnect, push sleeve back and pull out plug.(THIS AUTOMATICALLY SHUTS OFF GAS.)Permanent InstallationCAUTION: GAS PIPING TO YOUR GRILL MUST BE INACCORDANCE WITH LOCAL CODES. IN THE ABSENCEOF LOCAL CODES, USE THE NATIONAL FUEL GASCODE ANSI Z223.1/NFPA 54 (LATEST EDITION) ORCAN/CGA B-149.1, NATURAL GAS AND PROPANEINSTALLATION CODE.CAUTION: THE GAS SUPPLY MUST BE TURNED OFF ATTHE GRILL WHEN THIS APPLIANCE IS NOT IN USE.When ordered for use with Natural gas, the Sterling G-Series grill comes adjusted to operate with Natural gas.Qualified personnel should install the gas line. A Shut-offValve at the grill is required. This Valve must be designcertified by CSA International.The grill and Shut-off Valve must be disconnected fromthe gas supply piping system during any pressure testingof the system at test pressures in excess of 1/2 PSIG (3.5kPa).The grill must be isolated from the gas supply pipingsystem by closing its individual manual Shut-off Valveduring any pressure testing of the system at test pressuresequal to or less than 1/2 PSIG (3.5 kPa).Gas Leak TestWARNING: DO NOT USE OPEN FLAME TO PERFORMLEAK TEST!WARNING: DO NOT ATTEMPT TO USE THE GRILLWHEN YOU SMELL GAS OR FAIL A GAS LEAK TEST.Make sure there is no open flame near the grill duringthe test. Test for leaks every time the gas is re-connected.Procedure:1. Turn all Burner Output Knobs to OFF.2. Open the Gas Supply Valve slowly. Apply soapywater solution to all connections including factoryconnections.3. Look for bubbles around the connections. If bubblescan be seen, close the Gas Supply Valve and tightenthe connection where the bubbles are. Then, repeatsteps 1 and 2. Make sure you don’t over-tighten theconnections.4. Proceed with grill use.Gas Connection continued8 Revised 9/04SLEEVEREGULATORTOTOTOREGULATORREGULATORSOCKETSOCKETSLEEVETOTOTOGRILLGRILLGRILLPLUGPLUG(FIGURE C.)(FIGURE B.)(FIGURE A.)Figure 4. Quick Disconnect Fittings