TM8000 Mobile Radio Accessories Manual TMAA01-01 Line-Interface Board 21March 2004 © Tait Electronics Limited2.3 Installing the Line-Interface BoardNote The line-interface board link options must be set before the boardis installed in the radio, as the top side of the line-interface boardis not accessible once the board is screwed to the radio lid.2.3.1 Parts RequiredThe following table describes the parts required to install a line-interfaceboard in a radio. The parts marked with an asterisk (*) are not shown inFigure 2.2 and are used to connect to the radio’s external options connector.2.3.2 Installation Procedure1. Disassemble the radio in order to gain access to the options cavity.For detailed disassembly instructions, refer to the disassembly proce-dure in the TM8100 Service Manual.The circled numbers in the following instructions refer to items in thediagram on the previous page.2. Remove the top cover and lid b from the radio to access theoptions cavity.3. Remove the external options connector bung c, if it is fitted.4. On the inside of the radio lid place the foam seal d over the externaloptions connector cavity e.5. With the top side of the line-interface board f facing the radio lid,guide the external options connector g (the D-range connector onthe line-interface board) into the external options connector cavity.Table 2.5 Line-interface installation parts requiredQuantity Internal Part Number Description Figure 2.2Reference1 362-01110-XXaa. Contact Technical Support for the exact IPN.foam seal d1 362-01108-XXa cover seal 1!2 347-00011-00 4-40x3/16 screws 1@2 354-01043-00 screw-lock fasteners h6 349-02062-00 M3x8 screws j*1 240-00010-80 D-range plug —*1 240-06010-29 D-range hood —
