64 TMAA10-02 Handset TM8000 Mobile Radio Accessories ManualMarch 2004 © Tait Electronics Limited4. Connect the five wires to the handset PCB connector c.7.1.3 Handset Installation1. Press the pushbutton and remove the handset from the locking cradle.2. Disassemble the locking cradle by removing the four locking cradlescrews.3. Screw the handset mounting plate to the required mounting surface.Note that mounting screws are not provided in this kit.4. Clamp the top part of the locking cradle onto the mounting plate,and secure it with the four locking cradle screws.7.1.4 Connecting the Handset to the RadioImportant The handset microphone grommet must be installed when-ever the handset to radio cord is plugged into the microphonesocket. When installed, the grommet has two functions: to prevent damage to the microphone socket when thereis movement of the microphone cord, and to ensure that the control head is sealed against water,dust and other environmental hazards.1. Plug the radio to microphone cord into the microphone socket onthe radio control head.2. Slide the grommet along the cord and push two adjacent corners of thegrommet into the microphone socket cavity.3. Squeeze the grommet and push the remaining corners into position.4. Check that the grommet is seated correctly in the cavity.Table 7.1 Handset PCB connector wiringHandset PCBConnector Colour Reference2 white d3 blue e8 brown f9 yellow g10 green hbcd e f g h
