312 TPA-AA-201 Accessory Connector Kit TP9100 Service Manual© Tait Electronics Limited May 200516.2 Disassembly and Reassembly1. Use a Torx T6 screwdriver to remove the screw B, and remove theaccessory housing seal C, the accessory seal plate D, and the accessoryconnector PCB E.2. Use pliers to pull out the clamp G, and remove the strain relief I,and the insert H.Important During reassembly, make sure that the accessory housingseal C is inserted correctly inside the accessory connectorhousing F.Reassembly is carried out in reverse order of the disassembly.Figure 16.2 Components of the accessory connector kitB Torx T6 screw F accessory connector housingC accessory housing seal G clampD accessory seal plate H insertE accessory connector PCB I strain reliefTorx T63lb·in (0.34N·m)HCDEFGIB