Takara Belmont RS III PRIME Installation Instructions Manual

111. Attach the vacuum breakerFaucetWater OutletHot Line(Red)Cold Line(Blue)Spray HoseBrass Hex NutRubber GasketMetal Washer1) Insert #550 Faucet with Rubber Gasket into Bowlas shown.2) Place Metal Washer over threaded body of Faucetand tighten securely with Brass Hex Nut.Make sure the pointed tip on handle is pointed torear of the bowl.Note : Secure the flexible hose of Faucetprior to mounting bowlNote : Flushing hot and cold lines before attachingFaucet recommendedNote : Apply clear silicone sealant as requiredaround fittings for a water tight seal.Note : Use pipe sealing tape on threads2. Attach the faucetVacuum BreakerVacuum BreakerRubber GasketHoseReceiver CapRubber Gasket forHose ReceiverCap MountingWasher (2)BrassHex Nuts (2)Pipe Nipples (2)Mounting BarFastening Boltand Wing NutFront1) Preassembled Vacuum Breaker, Vacuum BreakerRubber Gasket, Hose Receiver Cap and pipenipples with the short pipe installed in line withthe arrow that points down on the vacuum breakerbody.Note : Use pipe sealing tape on threads at both endsof the nipples2) Attach the assembly with Hose Receiver RubberGasket to the bowl and place the Fastening Boltand Wing Nut through the Mounting Bar.Align and tighten securely by hand only.Do not over tighten.3) Attach connecting hose (G 1/4 L800) to the longpipe nipple. (arrow pointing up)Insert spray hose through opening in hose reveiver cap andattach to the outlet on the vacuum breaker (short pipe nipple, arrow pointing down).Connect G 1/4 L800 connecting hose to the inlet on the vacuum breaker (long pipenipple, arrow poinging up) and the other end of outlet on the faucet.3. Connect the hoses