Takara Belmont Salon Console Installation Instructions Manual

Also see for AY-CU-SX1: Operating instructions

Contents

InstallationPlace the platforms and connect them by joint bracket.Set a level gauge as shown in the illustration. Adjust the adjusterbolts and level the platforms.Precaution before installation1 Setting platformHot water / water supply pipe, Drain pipeInstall the pipes of cold water supply, hot water supply and drain correctly referring to the dimensions and theplumbing layout.WallIf the wall material is plaster board (fire prevention board, add a wooden reinforcement (12mm-thick composite panel[see page 2] )Level gaudeThis face needs tobe horizonalJoint bracketPlatformAdjuster boltPlace the basin body on the platform while aligning thecenter of the basin body with the center and betweenbasin body fixing screw hole.Press the basin body to the plate of the platform.Secure the basin body to the platform with suppliedwood screw into basin body fixing screw hole.[M4×16 Tapping screw…2]Setting basin body2Basin bodyPlatformCenter of basin bodycenter guide holeBasin body fixingscrew holePlateInstalling locationWhen installing the custom type to the wall, keep clearance of at least 30 mm; or install KF-SCWS Salon ConsoleWall Spacer between the unit and the wall (regardless that the wall is in the left corner or the right corner).NG OKThe door hits the wall.SideunitBasin body SideunitW.L.W.L.The door opens tothe end.Basin bodyW.L.W.L.The illustration above shows when installed at the right corner. (Same as when installed at the left corner.)Keep clearance of at least30 mm, or installKF-SCWS Salon ConsoleWall Spacer.