-8-Check ValveFlexible PipePackingStop ValveWater SupplyHot Water SupplyDrain HoseVinylDrain PipeElbowPackingThe height of drain pipe should be less than 60mm.C A U T I O N1. Insert the elbow to the drain pipe from floor with seals.2. Adjust the length of drain pipe(VU40), so that theone end of drain pipe(VU40) may become on theedge of the base, and connect to elbow with seals.3. Connect the drain hose packing to the drain pipe(VU40).4. Through the drain hose clamp to the drain hose, andconnect the drain hose to the drain hose packing.The drain hose shall be free of dent.Attach the drain hose so as not to be folded.5. Fasten the screw of the drain hose clamp fordrain hose.Tightening too hard may damage the drain hose.Do not tighten too hard.6. Cover the elbow part with the vinyl.5-6. Drain Pipe Connection5-7. Water and Hot Water Supply Line Connection1. Install the stop valve to each supply pipe.2. Bend each flexible pipe to a suitable angle forconnection.Check the each connection for leaks.3. Connect the each Check Valve to the each stopvalve with the flexible pipe.Make sure all connection is surely fixed.please confirmed the water does not leak.Drain Pipe(VU40)C A U T I O NC A U T I O NElbow and drain pipe(VU40) are not includedwith shipment. Please prepare it beforehand.Do not tear up the vinyl which is covered the drain hose.C A U T I O NDrain Hose PackingDrain pipe(VU40)Stepped SectionDrain pipe(VU40)ElbowLess than 60mmDrain Pipefrom Floor Edge of Base PlateBase PlateInsert the drain hose packingto the drain pipe(VU40) untilthe stepped section hit to theend of drain pipe(VU40).Drain HoseBase PlateEdge of Base PlateVinylDrain pipe(VU40)Drain HosePackingDrain Hose ClampDrain HoseInsert it inthis lineMatch the center of the drain hose clampto this line of the drain hose.Fastening