104MAINTENANCEDaily Inspection (Every 10 Hours)Inspecting the Water SeparatorWARNINGStop the engine and allow the machineto cool down before performinginspection and maintenance.InspectionS : Closed1. Open the front cover.2. Inspect the water separator (1).If the red indicator ring (6) is sunk to thebottom of the case (4), no water is mixedin.If the red indicator ring (6) is floating, thereis water up to the bottom of the ring. Drainthe water and clean.Draining1. Place a pan under the drain valve (7).2. Close the lever (2).3. Open the drain valve (7) and drain thewater.If the water does not drain easily, loosenthe plug (8).4. Close the drain valve (7) and plug (8).5. Open the lever (2) and bleed the air.Refer to page 139 “Bleeding the Air fromthe Fuel System”.Inspecting and Replenishingthe Engine OilWARNINGStop the engine and allow the machineto cool down before performinginspection and maintenance.Inspection1. Open the engine hood.2. Pull out the dipstick (1) and wipe off theoil with a rag.3. Fully reinsert the dipstick (1), then pull itback out.4. Check the oil on the dipstick (1).The level should be between the upperlimit (H) and lower limit (L).If it is below the lower limit (L), replenish.Replenishing1. Remove the oil supply cap (2).2. Add oil up to the upper limit (H) of thedipstick (1).Problems could arise if the oil level is eithertoo low or too high.3. Tighten the oil supply cap (2).4. Start the engine, run it at low idle for about3 minutes, then stop it.5. After about 10 minutes, inspect the oillevel.L4G019L H 1 24 K3G002ONOFF63S542 178
