Quick start guide Settings27ENGLISH Setting the first printing line(TOF)You can use the TOF function for setting the position of the first printing line foreach paper source and each menu individually.Before using the TOF function (if fanfold paper is used), you first have to set thetear position (see above).Swing the soundproofing cover towards the front (see “Printer at a glance”,page 5).Press the Setup key. The printer changes to setup mode.Press the Adjust (2) key.Press the TOF (3) key.The paper is fed to the position where the bottom edge of thefirst printing line A is aligned with the tear edge B of theprinter. The factory setting for the first printing position(TOF) is 12/72". This is equivalent to the second line fromthe top.Press the < (2) or > (3) key to move the first printing line to the desired position.You can set values from 0 to 220/72" for fanfold paper or for single sheets.12/72" corresponds to a printing line.Adjust PaprpathMenu Char OnlineSetup21 3 4TOFHead Tear OnlineSetup21 3 4ComputerdruckerComputerdruckerABFormAdj= 12/72"*Set < > Exit OnlineSetup21 3 4Quick Start - en .fm Seite 27 Donnerstag , 17. Juni 2004 9:36 09