TallyGenicom T6212 Operator's Manual

Also see for T6200 Series: Product guide Datasheet Quick start guide

Contents

TallyGenicom T6212 Operator's Manual Manual pdf 46 page image

Operator Manual3–10IPDSIn the IPDS emulation, the margin settings are absolute in regards to columnnumber, so that changing the CPI also changes the physical location of themargin.Right MarginYou can place the right margin at any column number across the page. As withLeft Margin, the range of this value depends on the CPI. (Column 136 is theDefault selection). The right margin must be greater than or equal to the leftmargin.IPDSIn the IPDS emulation, the margin settings are absolute in regards to columnnumber, so that changing the CPI also changes the physical location of themargin.If a requested margin setting indicates a column number that is greaterthan the maximum allowable for the current CPI, the printer will default tothe last valid setting.The current value of the right and left margins reflects a physical locationon the form, and therefore, changes when the CPI setting changes. If thephysical location of the right or left margin does not exactly correspondwith a line position after changing the CPI (characters per inch) setting,there will be no current setting indicator (asterisk).Horz AdjustThe print position on the form may be adjusted horizontally in increments of1/30th an inch. The default option is 0.Vert AdjustThe print position on the form may be adjusted vertically in increments of 1/72ndan inch. The default option is 0.Print to End Of Form (EOF)Before changing paper it is best to print to the end of the current form. Thisparameter allows you to set up the printer to print to the end of the form auto-matically. The settings are On and Off, with the default at Off.For Print to EOF to function properly the last print line of the form mustcome before the perforation. If the Form Length setting allows printing togo over a perforation, it is possible for the printer to continue printing in apaper out situation without any paper in the printer, which may damagethe printer.If Print to EOF is ON:The printer automatically prints to the end of the form then stops. The displayreads Paper Out, the alarm sounds, and the FAULT indicator illuminates. Atthis point you can load the machine with more paper. After you load paper,ensure that the platen gap is closed, adjust the top-of-form location and makeCAREFUL!