Using Memory Location PointsLoading MEMO pointsMEM0 1MEMO 2Establishing new MEMOsRecalculation of MEMOsChecking MEMO pointsErasing2 autolocation points can be established in the 488's memory system.At the desired moment, hold the MEMO key and press the LOC 1 key.The MEMO 1 indicator will turn on, showing that the current tapelocation is loaded into that register.Similarly, if you hold MEMO and press LOC 2, the current tapelocation is loaded as memory point 2 into that register.Each time LOC 1 or 2 is pressed while MEMO is held down, a newmemory point is established, and the previous memory point iserased.A blinking MEMO indicator shown in the meter when the MEMO keyis held down shows the corresponding register already contains alocation memory.MEMO points can't be entered while the tape is locating to eitherMEMO point or during REPEAT.If the COUNTER RESET button is pressed, both MEMO points areautomatically recalculated, so they stay the same relative to theiroriginal tape positions.When the tape is stopped, hold STOP and press the desired LOC key.As long as the LOC key is held down, the content of the correspondingMEMO register will be displayed in the counter window.Both MEMO points are erased when the cassette is taken out from thecompartment or the power is turned off.25