Tascam CD 450 Owner's Manual

Also see for CD-450 CD-450: Technical documentation Service manual

Contents

8 TASCAM CD-450O ATTenuator —OptionalThis reduces the balanced analog output level by 12dB at maximum.P ANALOG OUTPUT Connectors(BALANCED) —OptionalA +4 dBu analog output signal is available at theseXLR-type connectors.Q DIGITAL OUTPUT Connector(AES/EBU) —OptionalThis delivers the AES/EBU format digital signal.R ANALOG OUTPUT Jacks(UNBALANCED)A -10 dBV analog output signal is available at theseRCA jacks.S DIGITAL OUTPUT Connector(COAXIAL)This is for connection of a coaxial digital cable.T REMOTE JackThe optional remote control unit is connected here.U FADER/EVENT START JackThis 3-conductor (tip-ring-sleeve) jack is used toswitch the deck between Play and Ready, as you oper-ate an external switch connected to a mixer fader.Alternatively, this jack also allows this deck to beremotely controlled as an event. ® p.11V TALLY JackThis 3-conductor (tip-ring-sleeve) jack is typicallyused for connection of LEDs to monitor the operatingstatus of the deck at a distance. This jack operatesthrough an open-collector current source; the collectorcurrent is 40 mA at maximum. The tip goes active atEOM or STOP time (as selected in the preference set-ting screen), and the ring goes active at PLAY. For thewiring of these conductors, see illustration under theheading, "Fader Start," p.11.( RC-450C Remote Control Unit —Optional )W PGM (Program) KeyA maximum of 30 tracks can be programed to play insequence. ® p.10X CHECK KeyThis is used to change tracks once programed in mem-ory or check programed tracks.Y A-B REPEAT KeyOnce you press this key during play, that point isstored in memory as the beginning point of a repeatloop, and a point where you press the key the secondtime is stored as the end of the loop. A third pressclears the loop.General Guide