TASCAM CD-450 9Settings you make here are stored in EEPROM so theybecome default settings.1 Hold STOP and press POWER to enter apreference setting mode.2 Use the SKIP keys to select the desired items.E)SEF = EOSET: End-of-Message triggeringtime setting; 5 to 35 seconds, in 5-sec-ond steps.FALLY = TALLY: Tally signal output timing; atEOM or STOP time.F_P{H = F-PCH: Fixed pitch; +/–12%FPLAY = TPLAY: Timer controlled play; On orOff.A_{ = A-CUE: Auto cue level; –72, –66,–60, –54 dBThey are factory preset toOFFEOMOFFOFF–72 dBrespectively.3 Set the necessary parameters with the SEARCHkeys.4 To terminate the preference settings, let"SEnd" (SEnd) show by operating the SKIPkeys, and then press any transport key (exceptfor the SKIP keys). The deck will go into themode pressed.* To reset all your settings and restore the factorypresets, hold the CLEAR key and press thePOWER switch once after turning the unit off.Preference SettingsSearch OperationsTracks1 If either LED (TIME or INDEX) is lit to the leftof the SEARCH MODE key, press this key toturn the LED off. When neither LED is lit, thedeck is in the track search mode.2 Enter the desired track number on the numerickeypad.Playback starts from the beginning of the trackspecified if you let the search operation start fromSTOP.*To specify track 5 for example, press 0 then 5.* If you enter wrong numbers, press CLEARbefore entering the correct numbers.Indexes1 Press the SEARCH MODE key to let the INDEXLED light up.2 Enter a track number then an index number onthe numeric keypad.The deck starts playing from the indexed pointdesignated if you let the search operation startfrom STOP.Time Points1 Press the SEARCH MODE key to let the TIMELED light up.2 Enter a track number then a time point.The deck starts playing from the time point desig-nated if you let the search operation start fromSTOP.Operations
