Tascam CD-RW700 Owner's Manual

TASCAM CD-RW700 153 - Playback operationsThe CD-RW700 can be used to play back CDs(including CD-R and CD-RW discs that have beenrecorded and finalized on other types of recorder), aswell as CD-R discs and CD-RW discs that have beenrecorded on the unit.3.1 Simple playback operations1 Press the OPEN/CLOSE key (3 or 2) to openthe disc tray.2 Discs should be inserted in the tray with thelabel uppermost.3 Press the OPEN/CLOSE key (3 or 2) to closethe tray again.When a disc is loaded into the unit, the displaybriefly shows TOC Reading., with a flash-ing period following the word “Reading” as the unitdetermines the contents of the disc. When the TOChas been read, the display shows (at the top left of thedisplay) one of the following:1 Press the PLAY key (I or L) to start playback2 Press the STOP key (H or J) to stop playback3 Press the PAUSE key (J or K) to pause play-back temporarily.The track number indicators at the bottom of the dis-play light, to show the available unplayed tracks. Ifthere are thirteen tracks on the disc, for example,indicators 1 through 13 will light. If there are morethan 20 tracks on a disc, the track number OVER indi-cator (at the bottom of the display) will light.3.1.1 Time display modesWhen playing back a CD (or in pause mode), thereare four different time display modes.In each mode, the current track number is given, fol-lowed by the time, as given below, e.g.10Tr 0:48Press the DISPLAY key (A or 6) to cycle throughthese time display modes, as described below:NOTEIf programmed playback has been selected (3.2,“Programmed order playback”), the elapsed time andtotal remaining time refer to the programmed mate-rial, not the whole disc.3.1.2 Track searchUse the MULTI JOG control B or the SKIP keys onthe remote control unit I to jump forward or back-ward by one track at a time, as shown on the display.Note that going forward from the last track of thedisc will “wrap round” to track 1, and going back-ward from the first track of the disc will “wrapround” to the last track of the disc.The track number indicators at the bottom of the dis-play shows the selected track (the lit indicator at theleft of the row of indicators).It is also possible to use the number keys on theremote control unit 3 to jump directly to a particulartrack:1 To play tracks 1 through 9, simply press theappropriate key (1 through 9).2 To play a track whose number is higher than 9,press the +10 key an appropriate number oftimes to set the “tens” digit of the track num-ber, followed by a single key to set the “units”digit. For example:Track 13 = +10, 3Track 30 = +10, +10, +10, 0On the remote control unit only, the SEARCH keysHcan be used to “fast-forward” and “fast-rewind”through the disc.3.1.3 Playback modesThe unit can be set to play back a single track, thewhole disc in the order in which it was created, thetracks of the disc in a random (shuffled) order, or aprogrammed order (see 3.2, “Programmed orderplayback”).CD A commercial pre-recorded CD or afinalized CD-RCD-R, NO TOC A CD-R which has yet to be finalizedCD-RW, NO TOC A CD-RW which has yet to be finalizedCD-RW A finalized CD-RW (this differs from a CD,as it may be unfinalized and erased)[blank] Unusable or unreadable disc or no discDisplay shows MeaningTOTAL Total elapsed time of the disc[blank] Elapsed time of the current trackTOTAL REMAIN Time remaining of the current discREMAIN Time remaining of the current track