1-Introduction8 TASCAM CD-RW9001 − IntroductionThe CD-RW900 has been designed for the playback ofCD-DA format discs and MP3 files recorded in ISO9660format: In addition to ordinary 5-inch and 3-inch CDs,it can also play properly recorded CD-R and CD-RWdiscs.≠ Always place the compact discs in the trays withtheir label facing upward.≠ To remove a disc from its case, press down on thecenter of the disc holder, then lift the disc out, hold-ing it carefully by the edges.≠ Avoid getting fingerprints on the signal side (oppositethe label side). Grime and dust may cause skipping,so keep discs clean and store them in their caseswhen not being played. To clean the signal side of adisc, wipe gently with a soft dry cloth from the centertowards the outside edge.≠ Do not use any record spray, anti-static solutions,benzene, paint thinner or other chemical agents toclean CDs as they could damage the delicate playingsurface. It may cause CDs unplayable.≠ Discs should be returned to their cases after use toavoid serious scratches that could cause the laserpickup to “skip”.≠ Keep discs away from direct sunlight, and places ofhigh heat and humidity. If left in such places, warpingcould result.≠ Do not affix any labels or stickers to the label sideof the disc. Do not write on the disc with a ballpointpen.≠ Do not insert discs that have adhesive remainingfrom tape or stickers that have been removed. If theyare inserted into the player, they could stick to theinternal mechanism, requiring removal by a techni-cian.≠ Do not use cracked discs.≠ Only use circular compact discs. Avoid using non-circular promotional, etc. discs.≠ The CD-RW900 cannot play unfinalized CD-R/RWdiscs.≠ Music discs with copy control, a compact disc copy-protection system, have been released form severalrecord companies aiming to protect the copyright.Since some of these discs do not comply with theCD specifications, they may not be playable on theCD-RW900.Handling of compact discsEnvironmental considerationsThe CD-RW900 may be used in most areas, but tomaintain top performance, and prolong operating life,observe the following environmental conditions:≠ The nominal temperature should be between 5°Cand 35°C (41°F and 95°F).≠ Relative humidity should be 30 to 90 degrees non-condensing.≠ As the unit may become hot during operation, alwaysleave sufficient space above the unit for ventilation.Do not install this unit in a confined space such asa book case or similar product, and do not put anymaterial goods on the unit.≠ Avoid installing this apparatus on top of any heat-generating electrical device such as a power ampli-fier.≠ Make sure that the unit is mounted in a level positionfor correct operation.NOTEThe voltage supplied to the unit should match the volt-age as printed on the rear panel. If you are in any doubtregarding this matter, consult an electrician.